Kk blackboard v5.5 manual

testing my kk board i got for £17 posted:D. Kkmulticopter V Controller BlackBoard. - With 3 pcs gyros, relying on potentiometer adjust gyro sensitivity. - Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode. The KKmulticopter is a KK flight controller board for remote control multicopters with 2,3,4 and 6 rotors.  · KKmulticopter Flash Tool is a tool to easily upload a firmware to your KKmulticopter board. KKMulticopter Blackboard v with config: TriCopter Y3 $ KKmulticopter Flash Tool. Hi, I just opened this thread to centralize the hole questions, ideas, informations and so on in one place, as I do not check all 3 pages of.

The copter was very unstable with the initial settings. I advise using a 4-point tether until the controls are tuned. Buy lots of extra propeller blades until you get it tuned. You can find manuals for the KKmulicontroller V flight controller, and the Radiolink RC components on the web that explain how to tune it. The plug with 3 wires goes ACROSS the remaining 3 ports on the kk board, on the inner signal pins. The other end goes to each of the 3 receiver outputs (elevator/pitch, aileron/roll and throttle), but only connect to the signal pin of each. In the picture, the black wire connects to the left-hand pin on the kk board and port 1 of the rx, red to. Kkmulticopter V Controller BlackBoard. - With 3 pcs gyros, relying on potentiometer adjust gyro sensitivity. - Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode. The KKmulticopter is a KK flight controller board for remote control multicopters with 2,3,4 and 6 rotors.

Kkmulticopter V Controller BlackBoard. - With 3 pcs gyros, relying on potentiometer adjust gyro sensitivity. - Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode. The KKmulticopter is a KK flight controller board for remote control multicopters with 2,3,4 and 6 rotors. V KK Flight Control Circuit Blackboard V KK Multicopter for RC 4 Axle KK Multicopter Quad Copter Aircraft UFO F www.doorway.ru: Industrial 7. KKmulticontroller SMD v Blackboard – Seeed Studio. (Picture by arch) On the left you see the output from the 10 pin AVR programmer and on the left the 6 pin port of the HK KK board. All you need to do is connect the correct pins to each other. 1 to 9, 2 to 2, 3 to 7, 4 to 1, 5 to 5 and 6 to